chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

A/T - Delayed Engagement/No Drive/Reverse After Start Up|Page 1774 > < Transaxle/Transmission - Automatic|Page 1765
Page 1
background image

Fluid Pump: Customer Interest
A/T - Delayed Engagement/No Drive/Reverse After Start Up

Models

1986 Domestic Front Wheel Drive With Automatic Transaxle

Subject

Delayed Engagement, No Drive, or Reverse After Start Up

Index

TRANSMISSION

Date

May 19, 1986

No.

21-08-86

P-1931
SYMPTON/CONDITION

After starting the vehicle, there is no drive or reverse for an abnormally long period of time (5 seconds or longer), or until shifting gears, or until the
engine is raced. This condition is most likely to occur after a hot soak of approximately one hours. It may also occur after an overnight soak. It is not
always repeatable.

DIAGNOSIS

Test the transaxle for engagement into drive and/or reverse after a hot soak. If there is no engagement for an abnormally long period of time (5 seconds
or longer), or until shifting gears or until the engine is raced, and if subsequent operation is normal, do the following repair.

REPAIR PROCEDURE

The above condition(s) can be caused by excessive front pump rotor clearance. Replacement of the front pump is necessary to correct this condition.

1.

Remove the transaxle per the appropriate 1986 service manual instruction.

2.

Remove the front pump assembly and check the rotor side clearance.

NOTE:

THE MOST ACCURATE METHOD TO CHECK ROTOR CLEARANCE IS BY USING THE PLASTI-GAUGE
METHOD AS FOLLOWS:

a.

Remove reaction shaft support from front pump housing.

A/T - Delayed Engagement/No Drive/Reverse After Start Up|Page 1774 > < Transaxle/Transmission - Automatic|Page 1765