Lebaron Coupe L4-135 2.2L SOHC Turbo VIN A FI (1989)
Front Door Window Motor: Service and Repair
REMOVAL
Conventional Regulator
Power Window Regulator Mounting
1.
Raise the window to the "full up" position and place a block under the window glass to securely hold it in this position.[1]
2.
Disconnect the wiring harness from the power window motor.
3.
Remove the screw that secures the motor tie down bracket to the inner door panel (if applicable).
4.
Remove the three mounting screws that attach the window motor to the regulator. There are holes provided in the inner door panel to access the
mounting screws.
5.
Remove the window motor from the regulator by pulling it away from the regulator with a slight rocking or twisting motion.
6.
Remove the power window motor from the door.
Remarks
[1] Extreme caution should be used when working with any regulator that has a counterbalance spring. If the window is not secured in the "full up"
position, removal of the power window motor will allow the counterbalance spring to move the sector gear very quickly. This could result in either
personal injury or damage to the vehicle.
Cable Lift Regulator
Quarter Power Window Components
1.
Remove the convertible top slingwell assembly.
2.
Remove the quarter trim upper mouldings.
3.
Remove the cowl trim panels and the scuff plate panels.
4.
Remove the rear seat cushions and rear quarter trim panel.
5.
Position the window approximately 1/3 the way up.
6.
Remove the glass stabilizer.
7.
Disconnect the wiring plug from the window motor.
8.
Remove the quarter window assembly attaching screws and remove the window assembly from the car.
