Lebaron Coupe L4-135 2.2L SOHC Turbo VIN A FI (1989)
Tether Anchorage Sealing Washer
F
Plate - Child Seat Tether
1
Anchorage
INSTALLATION PROCEDURES
1.
Open the hatch and locate the three plastic caps (approximately 30 mm diameter) in the lower trim panel.
2.
(NOTE: ONLY USE THE CENTER LOCATION FOR THIS APPLICATION).
Remove the plastic cap.
3.
Using a screw driver, push the steel plug out of the sheet metal panel (the plug can be seen through the hole in the trim panel where the plastic cap
was removed).
4.
Insert the bolt through the plate, spacer, and the hatch opening panel.
5.
From the undersigned of the bumper, place the reinforcement on the bolt and hand tighten the flanged nut (assure that the foam sealer is positioned
next to the panel).
6.
While holding the plate as shown in the illustration, tighten the flange nut (tighten nut to 250 inch-pounds torque).
Pkg. No. 4519080
