Lebaron Coupe L4-135 2.2L SOHC Turbo VIN A FI (1989)
Anchorage
B
Spacer Child Seat Tether
1
Anchorage
C
Bolt - Child Seat Tether
1
Anchorage
D
Nut - Child Seat Tether
1
Anchorage
E
Reinforcement - Child Seat
1
Tether Anchorage Sealing Washer
F
Plate - Child Seat Tether
1
Anchorage
G
Template - Child Seat Tether
1
Anchorage Locating
INSTALLATION PROCEDURE
1.
5 Passenger Vehicle
Remove the rear seat from the vehicle.
7 Passenger Vehicle.
Remove the second rear seat from the vehicle.
2.
Place the template on the floor carpet.
3.
5 Passenger Vehicle
Position the template over the rear attaching cups in the floor pan with the passenger seat removed.
7 Passenger Vehicle
Position the template over the front attaching cups in the floor pan with the passenger seat removed.
4.
Locate the center of one of the two anchor locations shown on the template and transfer this location to the carpet.
5.
Remove the template.
6.
Using a sharp knife, cut a one-inch cross cut in the carpet and carpet underlayment at the transferred mark established in Step 4.
7.
Locate the depression (dimple) in the floor pan, located beneath the cross cuts in the carpet.
8.
Drill a 9 mm (3/8 inch) hole into the floor at the point marked by the depression.
9.
Cut a 25.4 mm (1.00 inch diameter hole in the carpet and underlayment around the hole in the floor pan).
10.
Insert the bolt through the plate, spacer, and floor.
11.
From the underside of the vehicle, place the reinforcement on the bolt and hand tighten the flanged nut (assure that the sealer side of the
reinforcement is placed against the floor).
12.
(NOTE: THIS OPERATION REQUIRES THE ASSISTANCE OF ANOTHER PERSON.)
While holding the plate as shown in the illustration, tighten the flange nut (tighten nut to 250 inch-pounds torque).
Pkg. No. 4519292