Lebaron Coupe L4-135 2.2L SOHC Turbo VIN A FI (1989)
Impact Sensor: Service and Repair
Fig. 96 Left Front Impact Sensor.
Before attempting to diagnose, remove or install any airbag system components, you must first disconnect and isolate the battery ground
cable. Failure to do so could result in accidental deployment and possible personal injury.
LEFT SENSOR
1.
Disconnect battery ground cable.
2.
Disconnect speed control servo from battery tray.
3.
Remove battery, battery tray and coolant bottle.
4.
Disconnect sensor electrical connector.
5.
Remove three screws holding sensor to radiator closure panel and remove sensor.
6.
Reverse procedure to install. Torque mounting screws to 100 inch lbs.
7.
Do not connect battery ground cable. Refer to Air Bag Systems/Testing and Inspection/Procedures.
RIGHT SENSOR
1.
Disconnect and isolate battery ground cable.
2.
Disconnect sensor electrical connector.
3.
Remove three screws holding sensor to engine side of closure panel and remove right sensor.
4.
Reverse procedure to install. Torque mounting screws to 100 inch lbs.
5.
Do not connect battery ground cable. Refer to DIAGNOSIS AND TESTING PROCEDURES/TESTING PROCEDURES/SYSTEM
CHECK for proper procedure.