Lebaron Coupe V6-181 2972cc 3.0L SOHC VIN 3 FI (1991)
Body system modules and engine components can be located by referring to the illustrations provided or in the individual diagnostic test procedures.
For wiring colors and proper wire placement in connectors, see HELP 3 - Inspection of Electrical Connectors.
Help 3 - Inspection of Electrical Connectors
Each time you disconnect a connector, inspect it thoroughly to determine that it is in good condition. Focus on the circuit being checked.
Dirt and corrosion are the biggest problems in connectors, causing voltage drop, open circuits, or other improper operation. Water and dirt in a connector
can allow voltage to "leak" into other circuits, leading to problems during damp/wet weather.
All wiring connectors in the body system can be disassembled for repair.
^
Inspect both sides of the connector for water, dirt or physical damage such as corrosion and pin push-outs. Pay attention to female connectors for
spread cavities.
NOTE: Use caution when testing wires to avoid damage to connectors.
^
Ensure that the connector is properly wired by verifying the wire color in each cavity against the appropriate pinout illustration. Correct any
miswired connectors.
Clean, repair, or replace the connector as necessary for proper vehicle operation.
