Lebaron Landau L4-153 2.5L SOHC Turbo VIN J FI (1990)
Power Window Motor: Service and Repair
REMOVAL
Power Window Regulator Mounting
1.
Raise the window to the "full up" position and place a block under the window glass to securely hold it in this position.[1]
2.
Disconnect the wiring harness from the power window motor.
3.
Remove the screw that secures the motor tie down bracket to the inner door panel (if applicable).
4.
Remove the three mounting screws that attach the window motor to the regulator. There are holes provided in the inner door panel to access the
mounting screws.
5.
Remove the window motor from the regulator by pulling it away from the regulator with a slight rocking or twisting motion.
6.
Remove the power window motor from the door.
Remarks
[1] Extreme caution should be used when working with any regulator that has a counterbalance spring. If the window is not secured in the "full up"
position, removal of the power window motor will allow the counterbalance spring to move the sector gear very quickly. This could result in either
personal injury or damage to the vehicle.
INSTALLATION
Power Window Regulator Mounting
1.
Position the power window motor on the regulator with the pilot properly aligned in the pilot hole of the regulator plate.
2.
Check the window motor drive gear and sector gears for proper mesh.
3.
Secure the window motor to the regulator with three mounting screws.
4.
Secure the tie down bracket with one screw (if applicable).
5.
Remove the window block.
6.
Plug in the wiring harness to the window motor.
7.
Test the system for proper operation before reinstalling door trim panel(s).
