Lebaron Sedan L4-134 2.2L VIN C 2-bbl (1984)
Fig. 6 Installing rotor vanes
Fig. 7 Installing pressure plate
1. Lubricate new O-ring seals with fluid and place in pump housing.
2. If drive shaft oil seal was removed during disassembly, lubricate new seal with fluid. Then install seal in pump body front hub, using a suitable
seal driver.
3. Position thrust plate and rotor on drive shaft. Then install rotor retaining ring in groove of drive shaft.
4. Place pump housing on work bench as shown and install two pump ring dowel pins in bore of housing.
5. Install drive shaft assembly in housing, making sure shaft seats properly.
6. Install pump ring in housing over two dowel pins with rotation arrow on ring to rear of pump housing. Arrow on outer edge of pump ring points in
direction of pump rotation (counterclockwise when viewed from rear of pump).
7. Install rotor vanes in slots of pump rotor, with radius edge of vanes toward outside of rotor.
8. Position pump housing on two wood blocks and push parts down into place as shown.
9. Lubricate outside diameter and chamfer of pressure plate with fluid to insure against damage to O-ring seals in housing. Then install pressure plate
in housing over dowel pins. Ported face of pressure plate goes toward pump ring.
10. Using a 23-4 inch diameter sleeve to apply pressure to outer edge of pressure plate only, press pressure plate in to seat. Pressure plate will travel
about 1-16 inch to seat. Do not press or hammer on center of pressure plate as to do so will cause permanent distortion resulting in pump
failure.
Fig. 8 Installing pressure plate spring
