chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Fuel Tank - Will Not Compeletely Fill|Page 2900 > < Fuel Tank - Will Not Compeletely Fill|Page 2894
Page 1
background image

Fuel Tank Vent: All Technical Service Bulletins
Fuel Tank - Will Not Compeletely Fill

Models

1985 Dodge Lancer, LeBaron GTS Vehicles With Electronic Instrument Clusters

Subject

Incomplete or Difficult Fuel Tank Fill

Index

FUEL

Date

June 17, 1985

No..

14-21-85

P-2132
SYMPTOM/CONDITION

A condition may exist on subject model vehicles where the fuel tank cannot be fully filled or is very difficult to fill. The fuel gauge on these subject
vehicles will normally stop one graduation bar below the full bar.

This condition may be caused by a fuel filler vent tube which is too long, and prevents sufficient venting on fuel filling. This vent tube will require
modification as outlined below.

REPAIR PROCEDURE

1.

Position vehicle on hoist.

2.

Disconnect negative battery cable.

3.

Remove fuel filler cap.

4.

Remove screws that secure fuel filler to quarter panel.

5.

Raise vehicle.

6.

Remove draft tube rubber cap from tank sending unit and connect either a portable holding tank or a siphon hose to draft tube. Drain fuel tank dry
into holding tank or properly identified "gasoline" safety container.

7.

Loosen the fuel tank straps and lower tank slightly, using a transmission jack to support tank.

8.

Remove left rear wheel and tire.

9.

Remove fuel filler tube from tank.

Fuel Tank - Will Not Compeletely Fill|Page 2900 > < Fuel Tank - Will Not Compeletely Fill|Page 2894