Lebaron Town & Country L4-135 2.2L SOHC Turbo VIN E FI (1985)
Throttle Position Sensor: Service and Repair
Fig. 6 Typical throttle body assembly
1.
Disconnect battery ground cable.
2.
Disconnect throttle body 6-way connector on all 1984-86 models and 1987 Shelby Charger or TPS electrical connector on 1987 models exc.
Shelby Charger, Fig. 6.
3.
Remove TPS-to-throttle body attaching screws.
4.
Unfasten wiring clip from convoluted tube, then remove mounting bracket.
5.
Lift TPS off throttle shaft and remove O-ring.
6.
Disconnect three TPS wires from convoluted tubing on all 1984-86 models and 1987 Shelby Charger.
7.
Lift each locking tab inside 6-way connector with a small screwdriver and remove TPS wire blade terminals. Note position of wires for assembly
reference.
8.
Reverse procedure to install, using new O-ring. Torque TPS attaching screws to 17-20 inch lbs.