chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Fuel System - Vapor Lock|Page 2076 > < Fuel System - Vapor Lock
Page 2
background image

use existing fuel tank)

ORDER THIS KIT TO BE USED WITH EACH OF THE ABOVE KITS

1 - 2.6L Engine K & E Body Pressure Regulator & Fuel Reservoir Kit

PN 4342937

Refer to parts lists for contents of each package.

To be ordered separately:

1 - Authorized Modification Label

PN 4275086

NOTE:

IT IS IMPORTANT THAT THE SPECIFIED MODEL YEAR APPLICATION KIT BE SELECTED. THE USE OF AN
IMPROPER PART NUMBER KIT MAY CAUSE THE CAR TO RUN OUT OF FUEL WELL BEFORE THE GAUGE READS
EMPTY.

Repair Procedure

To install electric fuel pump, regulator, and fuel reservoir.

A.

Engine Compartment Wiring Harness PN 4304992

1.

Disconnect the battery.

2.

Remove engine side of bulkhead connector. Depress fingers of instrument panel half of bulkhead connector, and push connector back through
hole into passenger compartment.

FIGURE 1-A - UNDER HOOD WIRING

3.

Route engine compartment overlay harness, PN 4304992, across the cowl and down right fender shield to coil. Secure to main engine harness
(on vehicles with harness routing as shown in Figure 1-A) with seven tie wraps, PN 6015756, evenly spaced (Figure 1-A). On vehicles where
main harness routing is different than in Figure 1-A, tie wrap overlay harness to convoluted hose harness.

NOTE:

BE SURE ANY LOOSE WIRING IN THIS AREA IS KEPT WELL CLEAR OF THE ENGINE ACCESSORY DRIVE
BELTS AND ENGINE MOUNT.

Fuel System - Vapor Lock|Page 2076 > < Fuel System - Vapor Lock