1998 LHS V6-35L VIN G Brake Booster Specs - Page 4545
Wiper Crank Lever Positioning
13. Rotate the windshield wiper motor crank lever until the crank lever points in the 12 o'clock position.
14. Slide the vacuum booster out of the dash panel, and remove from vehicle.
CAUTION: Do not attempt to disassemble the vacuum booster. It is serviced ONLY as a complete assembly.
INSTALL
1. Position vacuum booster on dash panel.
2. Install and tighten the 4 power brake booster to dash panel mounting nuts to 29 Nm (250 inch lbs.) torque.
3. Using lubriplate, or equivalent, coat the bearing surface of brake pedal pin.
4. Connect vacuum booster input rod to brake pedal pin and install a NEW retainer clip. Use only a new retainer clip DO NOT USE the old clip.
NOTE: Before installing master cylinder, reposition under hood wiring harness above master cylinder mounting studs, in front of booster.
5. Carefully position master cylinder on vacuum booster. Position wire harness routing bracket onto right master cylinder mounting stud.
6. Install and tighten the 2 master cylinder to vacuum booster mounting nuts to 29 Nm (250 inch lbs.) torque.
7. Reconnect brake fluid level sensor connector.
8. Connect all vacuum hoses onto the vacuum booster check valve.
9. Check stop light switch operation.
10. Install the wiper module reinforcement on the vehicle. Install the 8 bolts, attaching the reinforcement to the strut towers. Install the bolt attaching
the wiper module to the reinforcement.
11. Install the covers over the wiper module and the cowl. Install and securely tighten the attaching screws.
12. Reconnect the battery ground cable to the ground stud on the shock tower.
13. Turn windshield wipers on, then off, in order to park wipers in the proper position before installing wiper arms.
14. Install the wiper arms on the pivots. Install and securely tighten the wiper arm to pivot attaching nuts. Install the caps on the wiper arms covering
the pivot nuts.
15. Verify proper operation of the brake booster and brake system.
