LHS V6-3.5L VIN G (1998)
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove snap-on center bezel which holds the ATC Control.
3. Disconnect the ATC Control from the vehicle wiring harness.
4. If the ATC in-car temperature sensor (fault 26) is verified to be bad, then the ATC control section of the assembly must be replaced. If the ATC
in-car sensor does not pass the paper test, then the problem may only be with the ATC In-Car Sensor Fan-Motor assembly.
5. Remove the fan-motor assembly from the ATC control with two screws located on the back of the ATC control.
6. Replace only the fan-motor assembly if control does not pass the paper test, but passes with no fault code 26 (bad thermistor).
NOTE: Retest control. If ATC control still fails the paper test, then replace the ATC control and the fan-motor assembly. The ATC Control must
be replaced it the part fails fault code 26 (after confirming proper wiring connections).
INSTALLATION
-
For installation, reverse the above procedures.
