LHS V6-3.5L VIN G (1998)
Brake Light Switch: Testing and Inspection
Stop Lamp Wiring
1. Remove the stop lamp switch refer to Stop Switch Removal/Installation in this section. Disconnect connector from stop lamp switch. Using an
ohmmeter, switch continuity may be checked as follows:
2. With switch plunger released, there should be continuity between Pin 5 and Pin 6.
3. With switch plunger depressed, there should be continuity:
-
Between Pin 1 and Pin 2.
-
Between Pin 3 and Pin 4.
4. If the above results are not obtained, the stop lamp switch is defective or out of adjustment.
