LHS V6-3.5L VIN G (1998)
9. Remove hub and bearing assembly from steering knuckle. It is removed by sliding it straight out of steering knuckle and off end of stub axle. If
hub and bearing assembly will not slide out of knuckle, insert a pry bar between hub and bearing assembly and steering knuckle and gently pry hub
and bearing from knuckle. If stub shaft is frozen to hub and bearing assembly tap end of stub shaft with soft face hammer to free it from hub and
bearing spline.
10. Remove the ball joint stud to steering knuckle attaching nut and bolt.
CAUTION: When lower control arm is separated from steering knuckle, do not let ball joint seal hit up against steering knuckle. If ball joint seal
hits steering knuckle, seal damage may occur. If ball joint seal becomes torn, replace seal before assembling lower control arm to knuckle.
