LHS V6-3.5L VIN G (1998)
Disc Brake Caliper Mounting
11. Install front brake caliper over braking disc and align with caliper mounting holes on steering knuckle. Install the caliper to steering knuckle bolts.
Tighten bolts to 19 Nm (168 inch lbs.).
Tightening Wheel Nuts
12. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence, until all nuts are tightened to half
specification. Then repeat the tightening sequence to the full specified torque of 129 Nm (95 ft. lbs.).
13. Lower vehicle to the ground.
CAUTION: When tightening hub and bearing assembly to stub shaft retaining nut, do not exceed the maximum torque of 163 Nm (120 ft. lbs.).
If the maximum torque is exceeded this may result in a failure of the driveshaft.
