LHS V6-3.5L VIN G (1998)
Sealing Boot Retaining Clamp Installed
7. Clamp sealing boot onto interconnecting shaft using Crimper, Special Tool C-4975 and the following procedure. Place crimping tool C- 4975 over
bridge of clamp. Tighten nut on crimping tool C-4975 until jaws on tool are closed completely together, face to face.
CAUTION: Seal must not be dimpled, stretched or out of shape in any way. If seal is NOT shaped correctly, equalize pressure in seal and shape
it by hand.
Boot And Clamp Positioning
8. Position the sealing boot into the tripod housing retaining groove. Install seal boot retaining clamp evenly on sealing boot.
9. Clamp sealing boot onto tripod housing using Crimper, Special Tool C-4975 and the following procedure. Place crimping tool C-4975 over bridge
of clamp. Tighten nut on crimping tool C-4975 until jaws on tool are closed completely together, face to face.
10. Install the driveshaft back into the vehicle.
