LHS V6-3.5L VIN G (1998)
Sealing Boot Retaining Clamp Installed
5. Clamp sealing boot on interconnecting shaft using Crimper, Special Tool C-4975 and the following procedure. Place crimping tool C-4975 over
bridge of clamp. Tighten nut on crimping tool C-4975 until jaws on tool are closed completely together, face to face.
CAUTION: Seal must not be dimpled, stretched or out of shape in any way. If seal is NOT shaped correctly, equalize pressure in seal and shape
it by hand.
6. Position outer C/V joint seal boot, into boot retaining groove on outer C/V joint housing. Install seal boot to outer C/V joint retaining clamp
evenly on sealing boot.
Crimping Tool Installed On Sealing Boot Clamp
Sealing Boot Retaining Clamp Installed
7. Clamp sealing boot onto outer C/V joint housing using Crimper, Special Tool C-4975 and the following procedure. Place crimping tool C-4975
over bridge of clamp. Tighten nut on crimping tool C-4975 until jaws on tool are closed completely together, face to face.
8. Install the driveshaft requiring boot replacement back on the vehicle.
