LHS V6-3.5L VIN G (1998)
Windshield Washer Spray Nozzle: Service and Repair
Right Hood Nozzle
Windshield Washer Nozzle
REMOVAL
1. Remove the underhood silencer pad clips (only along the rear of hood).
2. Carefully pull silencer pad away from the hood.
3. Disconnect the right nozzle hose at the "Y" connector.
4. Disconnect hose from the two hose clips.
5. Using a long and narrow straight screwdriver, position tip against nozzle retention tab and apply sufficient force to disconnect nozzle from hood.
6. Pull nozzle and hose away from outside of hood.
7. Disconnect right hose clips from hood (if required).
INSTALLATION
1. For installation, reverse the above procedures.
2. During assembly of nozzle and hose to hood, gently pull on hose to assure hose is not kinked and nozzle body is securely snapped into position.
3. After connecting hose to "Y" connector, check for proper system function and to assure leak free connections by actuating the washer system
switch from inside of vehicle.
Left Hood Nozzle
REMOVAL
1. Remove underhood silencer pad clips only along left rear of hood.
2. Carefully pull silencer pad away from hood.
3. Disconnect left nozzle hose at "Y" connector.
4. Using a long and narrow straight screwdriver, position tip against nozzle retention tab and apply sufficient force to disconnect nozzle from hood.
5. Pull nozzle and hose away from outside of hood.
INSTALLATION
1. For installation, reverse the above procedures.
2. During assembly of nozzle and hose to hood, gently pull on hose to assure hose is not kinked and nozzle body is securely snapped into position.
3. After connecting hose to "Y" connector, check for proper system function and to assure leak free connections by actuating the washer system
switch from inside of vehicle.