New Yorker L4-135 2.2L SOHC VIN D TBI (1984)
Throttle Position Sensor: Service and Repair
Fig. 4 Exploded view of throttle body assembly
1.
Disconnect battery ground cable.
2.
Disconnect 6-way connector at throttle body.
3.
Remove TPS-to-throttle body attaching screws.
4.
Unfasten wiring clip from convoluted tube, then remove mounting bracket, Fig. 4.
5.
Lift TPS off throttle shaft and remove O-ring.
6.
Disconnect three TPS wires from convoluted tubing.
7.
Lift each locking tab inside 6-way connector with a small screwdriver and remove TPS wire blade terminals. Note position of wires for assembly
reference.
8.
Reverse procedure to install, using new O-ring. Torque TPS attaching screws to 20 inch lbs.