New Yorker L6-225 3.7L VIN E 1-bbl (1982)
Fig. 4 Removing or installing gear shaft and cover
Fig. 5 Removing steering column support nut
Fig. 6 Removing or installing power train
4. Remove gear shaft cover nut.
5. Rotate wormshaft to position sector shaft teeth at center of piston travel, then loosen power train nut.
6. Install tool C-3786 on sector shaft threaded end and slide tool into housing until tool and shaft engages bearings.
7. Rotate wormshaft to left stop, compressing power train components, then remove power train nut and housing head tang washer. Using a
screwdriver, pry on piston teeth to remove complete power train. The cylinder head, center race and spacer assembly and the housing head must be
kept in close contact since the reaction rings may become disengaged from grooves in cylinder head and housing. Also, the center head and
housing. Also, the center spacer may separate from center race and jam in the housing, in turn damaging the spacer and/or housing when removing
the power train.
Fig. 7 Removing worm shaft upper oil seal
8. Remove worm shaft upper oil seal, and disassemble column jacket support. Reaction seal may be removed from groove in face of jacket support
