chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

ABS/Brakes - Warning Lamps ON, ABS Motor Cycles|Page 5157 > < Brake Fluid|Service and Repair
Page 1
background image

Brake Fluid Accumulator: Customer Interest
ABS/Brakes - Warning Lamps ON, ABS Motor Cycles

Models

1988-89 C/AC Body With Anti-Lock Brakes

Subject

Hydraulic Assembly Accumulator Replacement

Index

BRAKES

Date

June 5, 1989

No.

05-02-89

(C05-06)
P-2168
BODY CODE LEGEND

C/AC - DYNASTY/NEW YORKER/LANDAU

SYMPTOM/CONDITION

The Vehicle must exhibit ALL of the following symptoms:

1.

BRAKE and ANTI-LOCK warning lamp illuminates during brake pedal application and extinguishes a few seconds later. If vehicle is in motion as
the warning lights extinguish, a series of clicks can be heard as the system goes through its self check.

2.

ABS Pump/Motor cycles for 1-2 seconds on every brake pedal application.

3.

No fault codes are stored.

DIAGNOSIS

1.

Confirm ALL symptoms above.

2.

Turn ignition off and discharge the Hydraulic Accumulator by pumping the brake pedal AT LEAST 25 times.

3.

Install hydraulic pressure tester (Tool # MST-6163).

4.

Turn ignition on and note the initial pressure reading. This is the accumulator precharge pressure.

5.

If accumulator precharge is below 500 psi, replacement of the accumulator is necessary.

WARNING:

BEFORE REMOVING THE PRESSURE TESTER, TURN THE IGNITION OFF AND DISCHARGE THE
HYDRAULIC ACCUMULATOR BY PUMPING THE PEDAL AT LEAST 25 TIMES.

Use the following procedure to replace the accumulator.

PARTS REQUIRED

1

Accumulator Package

P/N 4509005

REPAIR PROCEDURE

Replacement of the Hydraulic Accumulator requires removal of the Hydraulic Assembly from the vehicle. DO NOT ATTEMPT TO REPLACE THE
ACCUMULATOR WITH THE HYDRAULIC ASSEMBLY INSTALLED IN THE VEHICLE.

ABS/Brakes - Warning Lamps ON, ABS Motor Cycles|Page 5157 > < Brake Fluid|Service and Repair