New Yorker V6-181 2972cc 3.0L SOHC VIN 3 FI (1989)
Brake Fluid Pressure Sensor/Switch: Service and Repair
Early Production
Hydraulic Assembly
REMOVAL
1.
Depressurize hydraulic accumulator as outlined under MAINTENANCE PROCEDURES.
Warning: Failure to depressurize hydraulic accumulator, prior to performing this operation, may result in personal injury and/or
damage to painted surfaces.
2.
Remove electrical connector from hydraulic assembly.
3.
Unscrew control pressure switch from hydraulic assembly.
INSTALLATION
1.
Lubricate O-ring with clean brake fluid.
2.
Install O-ring inside metal spacer ring and install on control pressure switch.
3.
Install control pressure switch to hydraulic assembly.
