New Yorker V6-201 3.3L VIN R FI (1992)
Installation
1.
Before installing injectors lubricate the O-ring with a drop of engine oil.
2.
Install injector top into fuel rail cup.
3.
Install injector lock clip by sliding open end into injector slot, and onto the fuel rail cup side slots.
4.
Install injector electrical connector.
5.
Install fuel rail.
Note:
ASD and fuel pump relays remain energized for 7 minutes during the following test, unless the test is stopped or the ignition switch is turned to
the OFF position.
6.
Using scan tool, place ignition switch in "RUN" position and use Actuate Output Test "Auto Shutdown (ASD) Relay", to activate fuel pump and
pressurize system.
7.
Check for leaks.
