New Yorker V6-3.5L VIN F (1994)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
IAC Motor 3.5L
Idle Air Passage 3.5L
REMOVAL
1. Disconnect the negative battery terminal.
2. Disconnect the Idle Air Control (IAC) motor wiring connector.
3. Remove the mounting screws, and remove the IAC from throttle body, making sure the "O-ring is still on the IAC motor.
INSTALLATION
1. Install new IAC motor using a new O-ring.
NOTE: If the pintle measures more than 1 in. (25 mm), it must be retracted by using the DRB II scan tool. The battery must be connected for
this procedure.
2. Install the mounting screws, torquing them to 25 in-lbs (3 Nm).
3. Connect the IAC motor electrical connector.
4. Connect the negative battery cable.
