New Yorker V6-3.5L VIN F (1994)
Throttle Body: Adjustments
NOTE: Synchronize the throttle bodies if there is a gap between the adjustment screw and the linkage lever. Also, synchronize throttle bodies after
removal and installation.
Idle Speed Screw
Adjustment Screw
1. Install a 0.004 in feeler gauge between the idle speed screw and throttle lever on right throttle body.
2. Loosen the adjustment screw lock nut, on the synchronization shaft.
3. Turn adjustment screw until it just contacts the lever on the on the synchronization shaft. Tighten the lock nut to 36 in-lbs (4 Nm).
4. Check clearance between throttle lever and idle speed screw. The 0.004 feeler gauge should drag lightly when removed. Also a 0.006 inch feeler
gauge should not fit between throttle lever and idle speed screw.
