New Yorker V6-3.5L VIN F (1994)
8.
Remove the transfer chain snubber and screws and replace them with the parts listed in the Transfer Chain Snubber Kit. Tighten the snubber
screws to 5 N-m (40 in.lbs.).
NOTE:
DISREGARD THE SNUBBER GAP MEASUREMENT PROCEDURE. IT IS NOT REQUIRED WITH THE NEW RUBBER FACED
SNUBBER.
9.
Install the transmission rear cover. Tighten the attaching screws to 29 N-m (250 in.lbs.).
10.
Install the removed components in reverse order.
11.
Fill and adjust the transmission fluid level following the proper procedures.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
21-10-14-90
2.1 Hrs.
FAILURE CODE: P8 - New Part