Pacifica V6-3.8L (2008)
PLP Points
NOTE: If proper location marks are unavailable or as a check, the crossmember can be positioned utilizing the PLP points. Shift the
crossmember as necessary to achieve the measured distances shown in the figure.
36. Once mounts are lined up with location marks, tighten all four crossmember mounting bolts to 163 Nm (120 ft. lbs.).
37. Tighten shock absorber lower mounting bolts to 102 Nm (75 ft. lbs.).
38. Remove jack from under crossmember.
39. If equipped with AWD, install rear driveline module and both rear half shafts. See: Transmission and Drivetrain/Differential Assembly/Service
and Repair/Removal and Replacement/Rear Driveline Module/Installation
40. Install bolt (2) mounting right rear brake hose routing bracket to front of rear crossmember.
41. Install screw mounting left rear brake hose routing bracket to front of rear crossmember.
