Pacifica V6-3.8L (2008)
9.
Locate and unplug the Gray 16-way C2 connector on the Memory/Heated Seat Adjustable Pedals module (Fig 9).
10. Examine cavity 16 of the C2 connector. Is there a LG/OR wire in cavity 16 of the C2 connector? (Fig 8)
a.
Yes >>> Remove the wire terminal from the connector and tape the wire back to the wiring harness ensuring the terminal is completely
covered with tape. >>> continue with Step # 11.
b.
No >>> continue with Step # 11.
11.
Insert the wire provided in the kit, p/n 05183713AA, into cavity 16 of the C2 connector. Route the wire along the main seat harness bundle and
secure the wire to the harness using electrical tape (Fig 9).
12.
Place the driver's front seat into position for installation and reconnect electrical connectors to the Memory/Heated Seat Module.
13.
Place front seat studs into mounting holes.
14.
Install the seat headrest.
15.
Raise and support vehicle.
16.
Install four nuts attaching seat to floor pan. Tighten nuts to 88 N.m (65 ft. lbs.).
17.
If necessary, install vapor canister.
