Pacifica V6-3.8L (2008)
Steering Shaft: Service and Repair
Intermediate Shaft Lower Extension - Installation
INSTALLATION
1. Match splines inside intermediate shaft extension (3) with that on steering gear (5) shaft, then slide extension onto shaft.
2. Install roll pin fastening intermediate shaft extension to power steering gear shaft as follows:
a. Insert Installer (1), Special Tool 6831A, through extension (5) and steering gear shaft (4).
b. Slide roll pin (3) onto Remover shaft.
c. Thread knurled nut (2) all way onto end of Installer.
d. While holding Installer head stationary, turn hex nut pulling roll pin into shafts. Stop installing roll pin once it is centered intermediate shaft
extension.
e. Remove tool.
3. Lower vehicle.
