Pacifica V6-3.8L (2008)
17. Carefully mark location of rear crossmember on body at all four mount (bushing) locations using a marker or crayon (1). Do not use a scratch
awl to mark location.
18. If Equipped with AWD, place a reference mark on the propeller shaft-to-rear driveline module input flange connection and remove the three
propeller shaft-to-rear driveline module mounting bolts.Do not attempt removal of shaft from module at this time due to alignment pin
interference. Removal happens as crossmember is lowered in a later step.
19. Position under-hoist utility jack (2) or transmission jack under center of rear suspension crossmember (3) (without AWD) or rear driveline module
(with AWD). Raise jack head to contact driveline module/suspension crossmember and secure in place.
20. Remove lower mounting bolt and nut at each rear shock absorber (2).
