Prowler V6-3.5L VIN G (2002)
Front Door Window Motor: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the door trim panel.
3. Remove wire harness connector from motor.
4. Remove window regulator.
5. Remove window motor fasteners from regulator.
6. Remove window motor from regulator.
INSTALLATION
1. Install window motor to regulator.
2. Install window motor fasteners.
3. Install window regulator.
4. Connect wire harness connector to motor.
5. Install the door trim panel.
6. Connect the battery negative cable.