Prowler V6-3.5L VIN G (2002)
4. Tighten bolts gradually in sequence shown in (Fig. 124) until a torque of 12 Nm (105 in. lbs.) is obtained.
5. Install right side (Fig. 120) and left side (Fig. 121) intake manifold supports. Tighten bolts to 28 Nm (250 in. lbs.).
6. Install manifold support brackets at front corners and at MTV (Fig. 122). Tighten fasteners to 12 Nm (105 in. lbs.).
7. Connect vacuum lines to: Secondary Runner Valve, Speed Control Reservoir, Positive Crankcase Ventilation (PCV) Valve, Brake Booster, and
Proportional Purge Solenoid.
8. Connect electrical connectors to: Intake Air Temperature/Manifold Absolute Pressure (TMAP), Idle Air Control (IAC), Throttle Position Sensor
(TPS), and Manifold Tuning Valve (MTV).
9. Install EGR tubes to intake manifold.
10. Install throttle and speed control cables to bracket and throttle arm.
11. Install air intake duct.
12. Install upper radiator crossmember and front engine compartment supports.
13. Connect negative cable to battery.
INSTALLATION - LOWER
1. Clean all sealing surfaces.
NOTE: Gaskets can be reused provided they are free of tears, cuts, or deformation.
2. Inspect gaskets for tears, cuts, or deformation. Replace as necessary.
