PT Cruiser L4-2.4L (2008)
1. Position each header end molding to the inside of the windshield opening frame and if equipped, route the wire harness connector for the
illuminated sun visor through the hole in the molding.
2. Install each header end molding onto the windshield opening frame. Make sure the snap retainers are fully engaged to the windshield opening
frame.
3. Position the header center molding to the inside of the windshield opening frame.
4. Install the header center molding onto the windshield opening frame. Make sure the snap retainers are fully engaged to the windshield opening
frame and if equipped, the wire harness connector is positioned in the notch of the molding.
5. Install the sun visor and sun visor retainer See: Sun Visor/Service and Repair/Sun Visor - Installation.
Lower Quarter Trim - Removal
REMOVAL