PT Cruiser L4-2.4L (2008)
4. Install seat cushion side shields.
5. Place rubber bumper in position and press down to seat the bumper.
6. Install seat into vehicle. See: Service and Repair/Seat - Installation.
Seat Back Cover - Removal
REMOVAL
WARNING: Before servicing the seat back cover the airbag system must be disarmed. Failure to do so may result in accidental deployment of
the airbag and possible personal injury. Refer to restraint systems for service procedures.
1. Remove the front seat back. See: Seat Back - Removal.
2. For front seat illustrations See: Description and Operation/Seat - Description.
3. Remove the headrest (5).
4. Remove the seat back shield (if equipped).
5. Remove the J-strap from the bottom of the seat back.
6. Unzip the seat back cover zippers.
7. Remove the lumbar handle clip and handle (16).
8. Remove the seat airbag (19). See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Seat Airbag/Removal.
9. Remove the inboard (3) and outboard (4) headrest guides.
10. Remove the seat back frame lower shield.
11. Remove the heated seat harness retainers.
12. Cut the hog rings securing the cover to the seat cushion.
13. Remove the seat back cover (2) and cushion from the frame.
Seat Back Cover - Installation
INSTALLATION
WARNING: Before servicing the seat back cover the airbag system must be disarmed. Failure to do so may result in accidental deployment of
the airbag and possible personal injury. Refer to restraint systems for service procedures.