PT Cruiser L4-2.4L (2008)
1. Fold the guide pin bushing (1) in half lengthwise.
NOTE: To avoid damage to the bushing, do not use a sharp object to install the guide pin bushing in the caliper boss.
2. Insert the folded bushing (2) into the caliper (1) mounting boss until it is centered in the boss.
3. Unfold the bushing using fingers or a wooden dowel until the bushing is fully seated against the caliper boss bore. The bushing flanges should be
evenly seated (1) on both sides of the mounting boss (2).
4. Lubricate the inside surfaces of the bushing using Mopar Dielectric Grease or an equivalent.