PT Cruiser L4-2.4L (2008)
2. If the reservoir is being replaced, align the brake fluid level switch with its mounting hole on the left side of the master cylinder brake fluid
reservoir. Push the switch into the fluid reservoir until the switch retaining tabs (2) are expanded on the other side of the reservoir (1), locking it in
place.
3. Lubricate the reservoir mounting area with fresh clean brake fluid. Place the reservoir (1) in position over the grommet seals in the master cylinder
(2). Slide the reservoir into the grommet seals by firmly pressing down on the fluid reservoir. Once installed, make sure fluid reservoir is touching
the top of both grommet seals.
4. Install the fluid reservoir mounting screw (3). Tighten the screw to 4 Nm (35 in. lbs.).
5. Thoroughly bleed master cylinder before installing it on vehicle. See: Procedures
6. Install master cylinder on power brake booster. See: Removal and Replacement/Master Cylinder - Installation
