PT Cruiser L4-2.4L (2008)
REAR DRUM BRAKE VEHICLES
NOTE: The following procedure applies to either of the two rear parking brake cables.
1. From underneath, push the parking brake cable through the hole in the floor pan of the vehicle making sure the cable sealing grommet is installed
in the floor pan as far as possible (without going all the way through) to ensure a good seal.
2. Guide the trailing end of the cable (1) through the hole in the axle trailing arm (2).
3. Align the cable routing brackets with their mounts on the trailing arm and insert the studs. Install the two fasteners (3) securing the cable and
routing brackets to the trailing arm (2). Tighten the mounting nuts to 14 Nm (125 in. lbs.).
4. Install the parking brake cable into the brake support (backing) plate. Be sure the locking fingers on the cable retainer are expanded once the cable
is pushed all the way into the brake support plate hole to ensure the cable is securely held in place.
5. Install the parking brake cable on the parking brake cable actuating lever.
