PT Cruiser L4-2.4L (2008)
7. Remove the screws (1) that secure the air distribution housing (2) to the rear of the HVAC housing (3).
8. Remove air distribution housing from the HVAC housing by tilting the top of the air distribution housing rearward and disconnecting the
distribution housing from the tab-and-slot type retainers located at the bottom of the housing.
9. If required, disassemble the air distribution housing See: Overhaul/Disassembly/HVAC Housing.
Air Distribution Housing Installation
HOUSING-AIR DISTRIBUTION
NOTE: LHD model with A/C shown in illustrations. RHD and heater-only models similar.
1. Install the air distribution housing (2) onto the rear of the HVAC housing (3) by inserting the tabs on the bottom of the distribution housing into
the slots located on the bottom of the HVAC housing and tipping the distribution housing forward until it is properly aligned with the HVAC
housing.
2. Install the screws (1) that secure the air distribution housing to the HVAC housing. Tighten the screws to 2.2 Nm (20 in. lbs.).
