PT Cruiser L4-2.4L (2008)
Turn Signal Lamp: Testing and Inspection
SIDE REPEATER LAMP
NOTE: Battery must be completely charged (12v) prior to testing. It may also be necessary to install battery charger on the vehicles electrical
system when performing this test.
1. Remove the side repeater lamp bulb and check for burned out condition, replace bulb if necessary.
2. If bulb appears OK, reinstall the bulb in its socket and rotate the ignition switch to the ON position. Turn the appropriate turn signal lamp ON and
check for lamp operation. If lamp is still inoperative proceed to STEP 3.
3. Remove lamp bulb and check for power (12v) and ground connections in lamp socket. If power and/or ground connections are not present, trace
wire until open or short is found. Refer to Wiring Diagrams for a complete system schematic.
