PT Cruiser L4-2.4L (2008)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
Installation
INSTALLATION
When servicing throttle body components, always reassemble components with new O-rings and seals where applicable. Never use lubricants on O-rings
or seals, damage may result. If assembly of component is difficult, a light coat of engine oil may be applied to the O-RINGS ONLY to aid assembly.
1. The new idle air control motor has a new O-ring installed on it.
2. Carefully place idle air control motor into throttle body.
3. Install mounting screw. Tighten screw to 7 Nm (62 in. lbs.) torque.
4. Connect electrical connector to idle air control motor.
5. Connect negative cable to battery.
