PT Cruiser L4-2.4L (2008)
NOTE: The seat airbag connector must face down (toward seat cushion) after installation.
1. Carefully slide the side airbag in nylon sleeve until mounting studs line up with holes provided in nylon sleeve. Be careful not to tear nylon sleeve
as this will affect function of airbag system.
CAUTION: The side airbag must be inside the nylon sleeve before installing retaining nuts. Failure to do so will adversely affect the
function of the side impact airbag system.
2. Pull seat airbag and nylon sleeve assembly up to line up mounting studs with holes provided in seat back frame mounting bracket. Install the seat
airbag retaining nuts. Tighten to 8.0 Nm (70.8 in. lbs.).
3. Position the upper seat back trim cover and cushion over seat back frame.
4. Connect the seat airbag electrical connector. After initial connector is installed be certain the yellow locking tab is in the upper "locked" position.
Check to be certain connector cannot be removed once yellow locking tab is positioned.
5. Position seat back trim cover and install seat back trim cover J-straps on the upper, lower and airbag side of seat back frame.
6. Install the plastic back panel on the seat back (1). Install four screws in the upper mounting location of the back cover.
CAUTION: Be certain plastic back panel is securely installed on the seat back. Failure to do so will adversely affect the side impact
airbag system.
7. Install the front seat in vehicle See: Body and Frame/Seats/Service and Repair/Seat - Installation.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Supplemental Restraints
Verification Test
