PT Cruiser L4-2.4L (2008)
10. Release the connector (1).
11. Remove passenger airbag (2) from vehicle.
DEPLOYED AIRBAG
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component
service. Failure to do so may result in accidental airbag deployment, serious or fatal injury.
3. Roll/fold airbag towards instrument panel.
4. Close door over folded airbag and tape door closed.
5. Remove instrument panel top cover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel Cover - Removal.
6. Open glove box, push in on the box/bin sides and lower to floor.
7. Remove the right instrument panel end cap.
8. Remove four passenger airbag cover screws along the bottom end of the airbag cover.
9. Remove two passenger airbag cover screws along the top edge of the airbag cover.
10. Remove two nuts retaining passenger airbag to instrument panel assembly inside glove box opening.
