PT Cruiser L4-2.4L (2008)
15. Install the washer (4) on the end of the stud extending from the torque strut bolt at the crossmember.
16. Position the pencil strut (2) on the right front corner of the crossmember and body of the vehicle and install the mounting nuts (1, 3). Tighten the
nuts to 52 Nm (38 ft. lbs.).
17. Using a lint free towel, wipe clean the open power steering hose ends and the power steering gear ports. Replace the pressure hose used O-ring
with new. Lubricate the O-ring with power steering fluid.
18. On vehicles equipped with crossmember mounted power steering fluid coolers:
a. Place the cooler (2) in mounting position and snap the cooler tube going to the pump into the right routing clip on the front of the gear. Close
the routing clip.
b. Install the two screws securing the cooler to the front suspension crossmember (1). Tighten the screws to a torque of 10 Nm (90 in. lbs.).
