PT Cruiser L4-2.4L (2008)
3. Connect clutch master cylinder supply hose to brake master cylinder reservoir (1) and secure with clamp.
4. Fill clutch hydraulic release system with fluid:
a. 1.6L/2.4L N/A Models: Fill brake master cylinder to the top with suitable DOT3 fluid. Leave cap off. Raise vehicle on hoist.
b. Remove bleed port protective cap, and install suitable size and length of clear hose (2) to monitor and divert fluid into suitable container.
c. Release only the lower hydraulic tube snap ring (1), pull outward on tube (3) until it stops against the second ring, opening up the bleed circuit
and starting the air purge and fluid fill process.
d. Lower vehicle, but only enough to gain access to and fill the brake master cylinder.
e. Top off brake master cylinder fluid level while air is purged and fluid drains from bleed port. Continue this until no air bubbles are seen and a
solid column of fluid exists.
f.
Rapidly depress and release clutch peddle 10 times while purging. Insure the reservoir maintains fluid and the drain hose at the bleed port stays
submerged in fluid in a collection container.
g. Close hydraulic bleed circuit. Insert hydraulic pipe fully into slave cylinder and depress retaining ring. Remove drain hose. Replace dust cap
on bleed port.
