PT Cruiser L4-2.4L (2008)
2. Install spider assembly (1) onto interconnecting shaft with chamfer (3) on spider assembly toward interconnecting shaft (3).
3. Spider assembly (2) must be installed on interconnecting shaft (3) far enough to fully install spider retaining snap ring. If spider assembly will not
fully install on interconnecting shaft by hand, it can be installed by tapping the spider body with a brass drift (4). Do not hit the outer tripod
bearings in an attempt to install spider assembly on interconnecting shaft.
4. Install the spider assembly (2) to interconnecting shaft retaining snap ring (3) into groove on end of interconnecting shaft. Be sure the snap ring is
fully seated into groove on interconnecting shaft (1).
