PT Cruiser L4-2.4L (2008)
Seals and Gaskets: Service and Repair
Axle Shaft Seals
Removal
REMOVAL
1. Remove axle shaft. See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Half Shaft - Removal
2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1).
3. Tap on the pry tool (2) with a small hammer and remove axle shaft seal (1).
Installation
INSTALLATION
1. Clean axle shaft seal bore of any excess sealant.
2. Align axle shaft seal with axle shaft seal bore.
3. Install axle seal on Seal Installer 6709 and Handle C-4171 and insert into axle shaft seal bore.
4. Tap seal into position until seated against transaxle case.
5. Install axle shaft. See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Half Shaft - Installation
6. Check transaxle fluid level and adjust as necessary.