PT Cruiser L4-2.4L Turbo (2009)
5. Disconnect the vacuum hoses from the check valve (1) on the power brake booster, but do not remove the check valve from power brake booster.
6. Inside the vehicle, remove the silencer pad below the knee blocker.
7. Fold down and remove the knee blocker.
8. Remove the stop lamp switch (1) by rotating the switch counterclockwise approximately 30 degrees, then pulling it rearward out of the bracket.
Disconnect the wiring harness connector and discard the switch. Do not reuse the stop lamp switch.
9. Remove the retaining clip (4) securing the power brake booster push rod to the brake pedal. To do so, position a small screwdriver (1) under the
center tang of the retaining clip, then rotate the screwdriver enough to allow the retaining clip tang to pass over the end of the brake pedal pin (3).
Remove and discard the clip. Do not reuse the clip.
10. Slide the booster push rod (2) off the brake pedal pin (3).
