PT Cruiser L4-2.4L Turbo (2009)
Vacuum Brake Booster: Service and Repair
Power Brake Booster - Installation
LHD
NOTE: Before power brake booster (1) installation, be certain a NEW dash seal (2) is installed on the booster mounting studs.
1. Install the power brake booster by sliding the push rod and studs through the dash panel and into mounting position.
2. Under the instrument panel, install the four power brake booster mounting nuts (2, 3). Tighten the nuts to 34 Nm (25 ft. lbs.).
3. Using Mopar(R) Lubriplate, or an equivalent, coat the surface of the brake pedal pin where it contacts the brake booster input rod.
4. Install the power brake booster push rod on the pin mounted on the side of the brake pedal. Install a NEW retaining clip (1) on the end of the pin.
Do not reuse the old clip.
CAUTION: Do not reuse the original stop lamp switch. Anytime a switch has been removed or its position compromised, a new switch must be
installed and adjusted. Do not attempt to readjust the switch.
