PT Cruiser L4-2.4L Turbo (2009)
Turbocharger Coolant Line: Service and Repair
Turbocharger System Lines - Installation
TURBOCHARGER LINES
COOLANT SUPPLY LINE
1. If the brass fitting (1) was removed from the engine block, apply thread sealer to the threads and install into the engine block. Tighten the brass
fitting (1) to 41 Nm (30 ft. lbs.).
2. Position the coolant supply line tube (3) onto the brass fitting (1) at the engine block.
3. Install the after run pump hoses to the after run pump.
4. Install NEW washers on the banjo fitting of coolant supply line. Hand start the banjo bolt.
5. Tighten the flared fitting (2) to 31 Nm (23 ft. lbs.).
6. Tighten the banjo fitting bolts (2) to 30 Nm (22 ft. lbs.).
7. Lower the vehicle.
8. Fill the cooling system See: Service and Repair/Cooling System.
